Step By Step Guide For Linksys Velop Setup With Existing Router
The Linksys Velop works as a mesh network to enhance internet coverage by delivering faster speeds. Additionally, the web interface of this router is easy to access and you can carry out Linksys velop setup with existing router in just minutes. Further, to begin such a procedure, ensure an active network connection, smartphone/computer, and admin details of both networking devices.
To simplify this process further, we have shared this concise guide with you. It summarizes all the necessary facts regarding the Linksys velop setup with your existing router. In short, you don’t need to change or sell your present networking device. To learn more, keep reading this page!
How to setup Linksys Velop with existing router using simple steps?
Moreover, the web interface of the Linksys velop router is easy to access as mentioned above. Similarly, you can execute the Linksys velop mesh setup with existing router through the web address and Linksys application. Therefore, to understand the detailed steps for each method, must walk through this section:
Configuring the existing router the Velop using the web GUI
- In the beginning, place the Velop mesh and exiting router closer.
- Now, power on your Linksys mesh router and child nodes.
- After that, use your computer to connect to the Velop network.
- Next, run the web browser and enter linksyssmartwifi.com web address or 192.168.1.1 IP in the URL bar.
- Further, a login window is shown to you, write in the valid user details to access the admin account.
- Afterward, you are redirected to the Velop dashboard.
- Hereon, click the CA link at the bottom of the screen.
- Now, tap on Connectivity>CA Router Setup>Set a WiFi SSID & Password (enter strong network name and password)>Setup Node.
- You may lose the network connection temporarily, so wait until the router flashes, and then the LED on it turns solid blue.
- Next, click on OK and then on Apply.
- When you complete the setup process, the “Your Master Node is now Configured” notification appears on the screen.
- Lastly, you are all done with the Linksys velop setup.
Linksys velop setup with existing router via the app
- In the first place, check that the modem and master router are linked properly.
- Afterward, launch the Linksys application and enter the valid username/email and password on the login window.
- Place the master Velop router and child nodes within range of the existing router.
- Now, connect the existing router to the Velop master node ethernet cable.
- Hereon, access the admin account on the app by using the correct user details.
- After logging in, click on “Set up a new system” and choose your Velop model.
- Next, you are popped up to create a network SSID and Password.
- Here, tap on Save or Apply to implement the new network log in details.
- Afterward, select the Velop model that you use from the app dashboard.
- Again, the app scans for the Velop Network. When scanned, join this network.
- Power on the primary node and child nodes and ensure these blink purple.
- Further, add the child nodes one by one and click on Apply/Save.
- Similarly, configure other additional settings, like Guest Mode, Parental Control, etc. by proceeding with on-screen guidelines.
- Finally, your Velop is now linked to the existing router successfully.
Pro Tip: You can also use the 5-button method to add your existing router to the Velop mesh system.
Wrapping up
On the whole, you explore the detailed steps for performing Linksys velop setup with existing router. Additionally, we shed light on two different methods to configure your existing gateway to the Velop mesh. Hope, you find this guide helpful to understand this process!